Nord Lock M7

Anything related to Lambrettas... ask tech questions, post helpful info, or just read and learn.
GeorgeS
registered user
Posts: 254
Joined: Fri Feb 27, 2015 1:58 pm
Main scooter: 1961 Series II Granturismo 240
Contact:

I hadn't found this before, but I see SIP are selling M7 versions of Nord Lock washers. Anyone tried these on an gearbox endplate yet? There's no question on their ability with regards to vibration, but does their thickness cause a problem in this area?

https://www.sip-scootershop.com/EN/Prod ... gIRUPD_BwE
User avatar
jason frost
Dealer
Posts: 485
Joined: Wed Jan 07, 2009 11:45 am
Contact:

I have , worked fine but so does thread lock and flat washers , but I use set screws not studs and nuts
Grumpy225
registered user
Posts: 650
Joined: Sat Nov 24, 2012 7:59 am
Main scooter: Gori200, rt195, ld150,rb20
Location: Bakersfield, CA
Contact:

Split lock washers and a torque wrench works great. So far I haven't needed to use a nord lock washer or loctite on any part as long as the correct torque setting is used.

For clearance you should be fine. They are not excessively thick and there is a fair amount of room there.
Post Reply Previous topicNext topic
  • Information
  • Who is online

    Users browsing this forum: Ahrefs [Bot], Amazon [Bot], Google [Bot] and 14 guests