lambretta 290 rotax

[holty]

thats some neat welding on the basket why not try for an 8 plate packer plate for casing extend kickstart shaft go on holty be the first go on go on

ive got 2 5mm packers and the extended center bush and kickstart extension , i intend to get 2 sixplate conversions and see how many plates i can get in

[garry inglis]

Can't wait to see how that turns out I hope you have a slip joint in the exhaust to allow for packers

[holty]

i made the exhaust spring mounted at the stub, but didnt put a slip joint as its not going to need the barrel moving up or down as ive already machined my packer plate to the required thickness to get the port timings where they need to be. i made a small bettery tray the other day, plus a bracket for the fuel tank, got my external pick up, thats my next job.

[holty]

Untitled by stephen holt, on Flickr
Untitled by stephen holt, on Flickr
Untitled by stephen holt, on Flickr

[holty]

external pick up fitted and flywheel timing marks added and trigger
Untitled by stephen holt, on Flickr
clutch finished off just waiting for plates to arrive
Untitled by stephen holt, on Flickr
repaired rear brake pivot hole, reamed out hole and added 2 oilite bushes
Untitled by stephen holt, on Flickr
kickstart shaft and extending piece
Untitled by stephen holt, on Flickr
kickstart extended i had to extend the slot and made a packer to go behind the spring
Untitled by stephen holt, on Flickr

[garry inglis]

Great work holty that clutch looks deep

[holty]

thanks garry, ive polished the side case and fitted an sx kickstart
Untitled by stephen holt, on Flickr

[holty]

had a re think on the tank and moved it forward to make more room tor the carb, i will put my battery and tray somewhere else
Untitled by stephen holt, on Flickr

i have also added another bracket to the exhaust, fastens to 2 headbolts and has a rubber insert

Untitled by stephen holt, on Flickr

and today fitted new front sprocket, chain and 7 bgm race clutch plates and mb springs

Untitled by stephen holt, on Flickr

[holty]

so engine is all finished and ready to fit, so i have taken the engine out of my rb250 gp as that is what it is going in, done a small repair behind the number plate and fitted the tank upto now, been to rayspeed today and got the rest of the parts i need.
Untitled by stephen holt, on Flickr
Untitled by stephen holt, on Flickr
Untitled by stephen holt, on Flickr

[garry inglis]

The packers under the casing worked well did the kickstart work ok looks great