I've a dr 180 kit to put on a px . It doesn't have a head gasket .Is this right ?
Rich
dr 180
-
- registered user
- Posts: 1208
- Joined: Sat Mar 28, 2009 1:10 pm
- Location: hartlepool
- Contact:
No head gasket on last one I did.
Before you fit lap the cylinder and head. I would also hone it to get a better (larger) bore to piston clearance (very tight out of the box) . Finally gap the rings.
Before you fit lap the cylinder and head. I would also hone it to get a better (larger) bore to piston clearance (very tight out of the box) . Finally gap the rings.
-
- registered user
- Posts: 82
- Joined: Mon Jun 27, 2011 1:25 pm
- Main scooter: 1988 MotoVespa TX200
- Location: Helensburgh
- Contact:
I'm in the process of building one as well. What should the ring gap be ideally?gaz_powell wrote:No head gasket on last one I did.
Before you fit lap the cylinder and head. I would also hone it to get a better (larger) bore to piston clearance (very tight out of the box) . Finally gap the rings.
1983 Vespa PX125
1984 MotoVespa P200E
1988 MotoVespa TX200
1984 MotoVespa P200E
1988 MotoVespa TX200