SIL200, Ancilotti Clubman, Mikuni TM24 - jetting?

Check here for a list of various carb set-ups to help with jetting and all aspects of carb trickery!
adriang
registered user
Posts: 86
Joined: Mon Jan 12, 2009 8:42 am
Location: Brisbane, QLD, Australia
Contact:

Can anybody give an idea on carb set up for a SIL stage 4 200, TM24 (planning on running through the airbox, not sure if I'll put anything in it) and a clubman?

Been trawling the net, and quite a range of main jets and needles?

Just trying to figure out a decent starting point!!
User avatar
PaulO
registered user
Posts: 1
Joined: Sat Feb 28, 2009 9:03 pm
Contact:

185 main
15 Pilot
4dh7 needle (2nd from top clip position)
1.5 turn out on air screw.

Not through the airbox though,remote ram air on origional elbow
42mm ancillotti (sito)
done 2,000 + miles

Hope this helps.
Honeymonster
registered user
Posts: 45
Joined: Sun Mar 15, 2009 12:28 am
Location: Lincoln
Contact:

If the 4DH7 needle doesn't work, mine cut dead at every attempt to run it, try a 5N13-2 (-2 referes to the 2nd clip position) All else as suggested but final test the main with plug chops.

Ian
lozmondo
registered user
Posts: 193
Joined: Sun Mar 01, 2009 10:25 am
Location: Darkside of Aldershot
Contact:

As Honey monster but 190 main on an SR185.( thoght that being probably over cautious as running in) this after Dyno session yesterday which showed although 180 main was just ok it had a tendancy to lean off a little.
adriang
registered user
Posts: 86
Joined: Mon Jan 12, 2009 8:42 am
Location: Brisbane, QLD, Australia
Contact:

Thanks all, a useful starting point!
Post Reply Previous topicNext topic
  • Information
  • Who is online

    Users browsing this forum: No registered users and 11 guests