Jetting advice DR180
Posted: Mon Jun 18, 2018 8:54 pm
Asking for a buddy of mine, hoping to get a good starting point .
150 super engine (totally rebuilt)
Std crank (with electronic taper)
DR180 (just chamfered ports no more)
Sterling pipe
Std 20/20 carb
18° static btdc
What should we be looking at jetting wise, as we built this engine from bits from collective garages and are a bit unsure where to start?
Thanks in advance
Tony
150 super engine (totally rebuilt)
Std crank (with electronic taper)
DR180 (just chamfered ports no more)
Sterling pipe
Std 20/20 carb
18° static btdc
What should we be looking at jetting wise, as we built this engine from bits from collective garages and are a bit unsure where to start?
Thanks in advance
Tony