Building the engine right now, got to start carburation next week:
Engine: Stock Indian Stage 4, Piston Asso 2 thin rings, cases matched to the transfers and manifold matched to the ports.
Carb: OKO PWK 24 NO FILTER
Posible carb setup:
Pilot: 38
Needle: JJH
Main: 125
Timing: 17deg (Lightened Indian electronic flywheel BGM 120w stator)
Exhaust: JL3
Any advice wellcome.
Stock indian Stage four + OKO PWK 24 + JL3
Looks about right to me, air screw 1to 3/4 turn out & JJH needle seconds clip from top.
Best Regards
Chris
Chris