RZ Mk2 RH Exhaust fitment
Posted: Sun Jan 05, 2020 10:16 pm
Had an RZ Mk2 RH exhaust on a Polossi engine a couple of years ago and that was a perfect fit and ran well.
Bought a new stainless RZ Mk2 RH exhaust for my current T5 Polini and can hardly get the thing anywhere near to fit.
The endcan is nearly 4 inch off of where it should be and hangs way too low.
Anybody else tried to fit one of these?
Bought a new stainless RZ Mk2 RH exhaust for my current T5 Polini and can hardly get the thing anywhere near to fit.
The endcan is nearly 4 inch off of where it should be and hangs way too low.
Anybody else tried to fit one of these?