polini 180 kit is a p200 gearbox a good move running a 24 mm carb and a sip road????
or leave std 125 box and 150 cog clutch?
any thoughts appreciated.
vespa px 180 gearing solutions....
-
- registered user
- Posts: 330
- Joined: Mon Sep 28, 2009 12:44 am
- Contact:
-
- registered user
- Posts: 185
- Joined: Wed Jan 07, 2009 7:53 pm
- Main scooter: 1970 Dl125
- Location: Belfast, Ireland
- Contact:
I'm running an LML gearbox (p200 cogs, with 68 tooth primary) and a 22 tooth drive sprocket at the moment with a long stroke polini 187, 24 carb, sip road.
Lots of torque and it will easily pull another tooth on the clutch sprocket. Going 23/65 would depend on your weight and wether you ride two up or not.
Maybe p200 gears with a short fourth and 23/65 would be the way to go?
Lots of torque and it will easily pull another tooth on the clutch sprocket. Going 23/65 would depend on your weight and wether you ride two up or not.
Maybe p200 gears with a short fourth and 23/65 would be the way to go?
- Shaunbond
- registered user
- Posts: 161
- Joined: Sun Feb 15, 2009 6:00 pm
- Location: Preston, Lancs
- Contact:
I run a BGM 177 on LML reed cases, nothing special in terms of tuning with. BGM Touring exhaust and it runs 23/68 without issue. Loads of torque and smooth crusing.
Serial scooter rider...
VMSC Committed to Scootering for 25 years
VMSC Committed to Scootering for 25 years
- Muttley McLadd
- registered user
- Posts: 1496
- Joined: Wed Jan 07, 2009 6:32 pm
- Contact: