I've been trying to fit an MBD exhaust bracket to my JL3 today and pretty sure it can only fit one way but it would not line up any where near the bracket on the end can
Have there been any design changes in the past ? My exhaust is knocking on a bit now so it's possible I suppose??
JL3 End Can any design changes in the past?
- bazman
- registered user
- Posts: 578
- Joined: Wed Jan 07, 2009 9:02 am
- Playstation gamer tag: bazman70
- Location: Annan S.W. Scotland
- Contact:
Dazza wrote:I've been trying to fit an MBD exhaust bracket to my JL3 today and pretty sure it can only fit one way but it would not line up any where near the bracket on the end can
Have there been any design changes in the past ? My exhaust is knocking on a bit now so it's possible I suppose??
Some good photo's on this thread pal.
viewtopic.php?f=7&t=8294
- Dazza
- Posts: 534
- Joined: Wed Jan 07, 2009 8:48 pm
- Main scooter: S3 LI Rapido 225
- Location: Newark on Trent
- Contact:
No Martin, not a replacement can BUT..
I was looking at a couple of exhausts today with the same bracket fitted and noticed they sit a lot higher than mine, then I realised that like a fool I never tried undoing the two bolts on the main bracket to lift it higher, I left them tightened and expected the MB bracket to fit in the same place DOH!
So, I'll be trying it again tomorrow - it may even solve the problem I have with the u bend tw@77ing the LHS rear runner when I hit a pothole or cross a speed bump
Will let you know...
Daz
I was looking at a couple of exhausts today with the same bracket fitted and noticed they sit a lot higher than mine, then I realised that like a fool I never tried undoing the two bolts on the main bracket to lift it higher, I left them tightened and expected the MB bracket to fit in the same place DOH!
So, I'll be trying it again tomorrow - it may even solve the problem I have with the u bend tw@77ing the LHS rear runner when I hit a pothole or cross a speed bump
Will let you know...
Daz
If it aint broke.........tinker with it.....