any demand for these in brass
I'll have a set please!!
-
davidblythe
- registered user
- Posts: 298
- Joined: Wed Jan 07, 2009 7:19 pm
- Location: Cheam, Surrey
- Contact:
1st small length of brass arrived today
3 more small lengths ordered, hopefully come tomorrow
found a supplier sells by the bar
One bar length ie 3 metres is £38 plus Vat plus £25 delivery irrespective of no of bars delivered
in steel can get 5 bar for £35 delivered
make first set tonight
3 more small lengths ordered, hopefully come tomorrow
found a supplier sells by the bar
One bar length ie 3 metres is £38 plus Vat plus £25 delivery irrespective of no of bars delivered
in steel can get 5 bar for £35 delivered
make first set tonight
-
davidblythe
- registered user
- Posts: 298
- Joined: Wed Jan 07, 2009 7:19 pm
- Location: Cheam, Surrey
- Contact:
could i purchase a set please!
-
davidblythe
- registered user
- Posts: 298
- Joined: Wed Jan 07, 2009 7:19 pm
- Location: Cheam, Surrey
- Contact:
in the post tomorrow Markmarkdicko wrote:could i purchase a set please!
-
dirtyhandslopez
- registered user
- Posts: 465
- Joined: Sun Mar 22, 2009 5:15 am
- Location: Richmond Virginia, USA
- Contact:
They are done then? Who is on the list to get a set? I have a Mikek here that would love to meet themdavidblythe wrote:in the post tomorrow Markmarkdicko wrote:could i purchase a set please!
Sorry 'bout that, just saw the add in the market place
That's not going anywhere...
-
davidblythe
- registered user
- Posts: 298
- Joined: Wed Jan 07, 2009 7:19 pm
- Location: Cheam, Surrey
- Contact:
dirtyhandslopez wrote:They are done then? Who is on the list to get a set? I have a Mikek here that would love to meet themdavidblythe wrote:in the post tomorrow Markmarkdicko wrote:could i purchase a set please!
Sorry 'bout that, just saw the add in the market place
No worries on getting the brass now
did one set for a Mickeck, tightest curve on the U bend I have seen, it worked in the end but not an easy of the shelf if that makes sense, is the distance between flange and hitting the U Bend in a straight line 20mm if so can be done buy may need you to drill the holes in the correct place