Can anyone advise on whether this barrel should be repaired/or is cost too high?
As you may be able to see one of the spigots has partly broken off!!!!
Repairing an Italian 70mm barrel
Unless its somthing rare or exotic porting, I would say forget it... its going to cost around a £100 or more to put a spigot back on by fitting a steel liner...
- rog60
- registered user
- Posts: 588
- Joined: Fri Feb 13, 2009 7:18 pm
- Main scooter: Indian GP200
- Location: SWINDON (Wilts)
- Contact:
That's what I was thinking....................
I believe it to be an SX/TV barrel bored out to 70mmwith ports slightly enlarged and smoothed out.......
I believe it to be an SX/TV barrel bored out to 70mmwith ports slightly enlarged and smoothed out.......
Last edited by rog60 on Mon Jul 27, 2009 11:51 pm, edited 1 time in total.
NO IT'S NOT A F***IN* MOPED!!!!!!
-
- registered user
- Posts: 298
- Joined: Wed Jan 07, 2009 7:19 pm
- Location: Cheam, Surrey
- Contact:
have a TS barrell that has ran like that with no problems, chamfer it and the rest of the spigot will support the skirt,
but i am tight when it comes to spending money
if you run a jap piston you end up having to cut the spigot to match the cutaways
but i am tight when it comes to spending money
if you run a jap piston you end up having to cut the spigot to match the cutaways
-
- registered user
- Posts: 298
- Joined: Wed Jan 07, 2009 7:19 pm
- Location: Cheam, Surrey
- Contact:
thats a bit differentrog60 wrote:It also has a crack that runs nearly the remainder of the spigot width.................
- rog60
- registered user
- Posts: 588
- Joined: Fri Feb 13, 2009 7:18 pm
- Main scooter: Indian GP200
- Location: SWINDON (Wilts)
- Contact:
Yea, but you can't really see it........................davidblythe wrote:thats a bit differentrog60 wrote:It also has a crack that runs nearly the remainder of the spigot width.................
NO IT'S NOT A F***IN* MOPED!!!!!!
The piston will try to tip into the inlet and/or exhaust a little more than normal as the skirt is not fully supported... wear would, I think, be rapid... It would no doubt run... But how long is anyones guess...