Hi all,
Changed over from the original points to a full dc wassel set up. I'm struggling with the connections in the headlight and after some assistance.
I have the casa ignition switch without the park light option and using the MB universal loom.
I have a few wires left that I am unsure of, any ideas where they should be connected? This is where I am at the moment.
I have these remaining: yellow feed from the loom, the purple piggy back I will clip off.
A purple and brown from the ignition switch.
do I have some in the wrong position as well?
Thanks in advance
Tv175 battery to wassel full dc wiring help.
-
- registered user
- Posts: 388
- Joined: Tue Dec 20, 2016 2:27 pm
- Location: Switzerland
- Contact:
Yellow from loom needs to connect to the brown from ignition switch.
Use the purple piggy back to connect to the ignition switch purple.
Others look ok.
Use the purple piggy back to connect to the ignition switch purple.
Others look ok.
- jason frost
- Dealer
- Posts: 485
- Joined: Wed Jan 07, 2009 11:45 am
- Contact:
Should be an orange from the dip/horn switch to the orange on the ignition switch
-
- registered user
- Posts: 388
- Joined: Tue Dec 20, 2016 2:27 pm
- Location: Switzerland
- Contact:
I had to do a wire repair and unfortunately ran out so the last bit is grey, but labelled as orange.jason frost wrote:Should be an orange from the dip/horn switch to the orange on the ignition switch
-
- registered user
- Posts: 388
- Joined: Tue Dec 20, 2016 2:27 pm
- Location: Switzerland
- Contact:
Cheers, will try that in the next few days.firekdp wrote:Yellow from loom needs to connect to the brown from ignition switch.
Use the purple piggy back to connect to the ignition switch purple.
Others look ok.
-
- registered user
- Posts: 388
- Joined: Tue Dec 20, 2016 2:27 pm
- Location: Switzerland
- Contact:
All working many thanks, but had a weird situation with the rear light assy.
It has 4 connectors 2x marked M, 1x stop and the tail.
M is the earth but I found there wasn't an electrical connection between the terminal and the reflector/bulb holder despite being riveted together.
I made a solder joint and then it worked.
Next challenge is 3 out of 4 headlight rim screws line up, the 4th doesn't.. Typical
It has 4 connectors 2x marked M, 1x stop and the tail.
M is the earth but I found there wasn't an electrical connection between the terminal and the reflector/bulb holder despite being riveted together.
I made a solder joint and then it worked.
Next challenge is 3 out of 4 headlight rim screws line up, the 4th doesn't.. Typical