Hi all,
extreme long shot but I'm trying to find the engineering drawings that shows the dimensions and details of the main engine case... Any idea if these even exist?
Sent from my BND-L21 using Tapatalk
Looking for engine case engineering drawings
-
- registered user
- Posts: 388
- Joined: Tue Dec 20, 2016 2:27 pm
- Location: Switzerland
- Contact:
Yes they do
-
- registered user
- Posts: 388
- Joined: Tue Dec 20, 2016 2:27 pm
- Location: Switzerland
- Contact:
Well that's a start, so next step is where can I get the details for the hub bearing area?eden wrote:Yes they do
Believe Scootopia has them but if that doesn't work out who or where else?
Sent from my BND-L21 using Tapatalk
-
- registered user
- Posts: 4823
- Joined: Tue Oct 25, 2011 9:50 pm
- Main scooter: Lambretta
- Location: Lanarkshire
- Contact:
I'm guessing the guys who are currently producing casings - Casa, Uni, GT etc will all have their drawings but it's whether they'll share them - depends what you have in mind.
Maybe you should have asked if there were any in the public domain?
Perhaps if you approached one of them with a proposal they might be willing to help if it wasn't against their commercial interests?
Maybe you should have asked if there were any in the public domain?
Perhaps if you approached one of them with a proposal they might be willing to help if it wasn't against their commercial interests?
"Our dilemma is that we hate change and love it at the same time; what we really want is for things to remain the same but get better."
-
- registered user
- Posts: 388
- Joined: Tue Dec 20, 2016 2:27 pm
- Location: Switzerland
- Contact:
Cheers for all the replies, will contact those listed .
ZERO commercial use, I'm trying to save a case that's had significant damage around the hub bearing bore and to assist the remachine I'm wondering if the drawing shows datums or other measurements to help me find the centre.
Sent from my BND-L21 using Tapatalk
ZERO commercial use, I'm trying to save a case that's had significant damage around the hub bearing bore and to assist the remachine I'm wondering if the drawing shows datums or other measurements to help me find the centre.
Sent from my BND-L21 using Tapatalk
- Rich_T
- Dealer
- Posts: 540
- Joined: Fri May 29, 2009 8:07 pm
- Main scooter: Li Special
- Location: Birmingham
- Contact:
To find the centre line of the hub bearing you first need the the centre line for the case. The case centre line is between the rear side case dowel and the forward-most exhaust stud. Clocking off the centre of the gearbox lay shaft bearing, the rear axle centre line is 69.31mm aft. Hope that helps
-
- registered user
- Posts: 388
- Joined: Tue Dec 20, 2016 2:27 pm
- Location: Switzerland
- Contact:
Hi Rich,
Just sent you a message on Facebook with some details.
Sent from my BND-L21 using Tapatalk
Just sent you a message on Facebook with some details.
Sent from my BND-L21 using Tapatalk