Just bought this via mail order. My obvious concern is the holes in the casting on (or to the side) of the gasket face. Is there enough gasket face to seal on?
New cylinder head
Just bought this via mail order. My obvious concern is the holes in the casting on (or to the side) of the gasket face. Is there enough gasket face to seal on?
-
Powolotti
- Dealer
- Posts: 103
- Joined: Wed Jan 07, 2009 2:53 pm
- Location: 40 miles north of Vienna
- Contact:
looks like it has been welded and milled down on this pic..? You bought this as a new head?
anyway, if machined correctly I think it is safe to use
anyway, if machined correctly I think it is safe to use
meet me on Facebook: Michael Powolotti
some of my tuning work:
http://www.facebook.com/pages/Powolotti ... 6938811863
my club:
http://www.wiener-spitzbuam.at
some of my tuning work:
http://www.facebook.com/pages/Powolotti ... 6938811863
my club:
http://www.wiener-spitzbuam.at
Yes it has been reworked as you suggest which I'm not entirely happy about. Rebuild/machining and appears fine even though it looks shite.