Gearbox wont mesh
Thanks Fluff, just seen your reply. If you can measure 3rd gear diameter just to confirm what it should be, hopefully going to the garage tomorrow. Thanks.
-
- registered user
- Posts: 388
- Joined: Tue Dec 20, 2016 2:27 pm
- Location: Switzerland
- Contact:
No probs but will have to be Thursday afternoon before I'm back in the workshop
- jason frost
- Dealer
- Posts: 485
- Joined: Wed Jan 07, 2009 11:45 am
- Contact:
Li150 37 teeth 96.2mm SX200 37 teeth 95.6 mm
-
- registered user
- Posts: 388
- Joined: Tue Dec 20, 2016 2:27 pm
- Location: Switzerland
- Contact:
Sorry haven't replied yet. Had to.go away so will be middle of the week before I get to the workshop again
Don't worry..I know the feeling, can't get caught up with anything at the moment.