I was removing the bearing collar by dremeling a notch in the collar and using a chisel to tap it off when I slipped and scuffed the taper,
as you can see where I've circled the scuff - its quite near the flywheel side seal, its not a deep mark but you can pick it up if you run your fingers over it, is it knackered and would damage the seal or could I smooth it down and use it? thanks Paul
damaged crankshaft oil seal face?
- scooterslag
- registered user
- Posts: 409
- Joined: Wed Jan 07, 2009 12:23 pm
- Location: Sunny Barnstaple
- Contact:
The mack daddy on the left!
-
- registered user
- Posts: 7092
- Joined: Thu Aug 04, 2011 6:28 am
- Main scooter: honda
- Location: Fenland
- Contact:
We used to use repair sleeves with success.
https://simplybearings.co.uk/shop/Engin ... index.html
https://simplybearings.co.uk/shop/Engin ... index.html
The dark line running round the area shows where the seal runs. Smooth any roughness (to prevent inner seal damage on assembly) and carry on.
-
- registered user
- Posts: 5181
- Joined: Tue Apr 22, 2014 4:21 pm
- Main scooter: Lambretta li150 special
- Location: Lincoln
- Contact:
agree.Daggs wrote:The dark line running round the area shows where the seal runs. Smooth any roughness (to prevent inner seal damage on assembly) and carry on.
- scooterslag
- registered user
- Posts: 409
- Joined: Wed Jan 07, 2009 12:23 pm
- Location: Sunny Barnstaple
- Contact:
great, thanks for the replies, Paul
The mack daddy on the left!