I've a 2nd question for you ever so knowledgeable gentlemen
I'm going to be refitting my Jet leg shields and rear runners in the not so distant future.
When I removed them I had an assortment of fasteners holding them down every one had a
finishing washer with a either a pan head, Slotted countersunk flat head, slotted countersunk oval head
or a Philips oval countersunk.
I've been looking for a list of what goes where and what was originally used.
I think I need 12 finishing washers 12 x countersunk and 8 x slotted pan head
Are the Countersunk screws Slotted or Philips head, flat or oval ?
when I removed them, the Philips looks a little more corroded so could be older or just
of a shitty quality.
Does one of the shops sell a kit or do any of you guys know what's needed and where it goes?
Many Thanks
Jet 200 leg shield hardware
It's got the Mats
It may yet get some holes drilled a set of scootopia runners, rubbers and a hardware kit if I have no luck.
It may yet get some holes drilled a set of scootopia runners, rubbers and a hardware kit if I have no luck.
-
- Dealer
- Posts: 16
- Joined: Sun Oct 16, 2011 10:23 pm
- Main scooter: Jet 200 p200e
- Location: Halifax
- Contact:
phillips are original on Spanish scoots
Many Thanks for the info.buzzsolomoto wrote:phillips are original on Spanish scoots