Jet 200 leg shield hardware
Posted: Wed Dec 21, 2016 9:40 pm
I've a 2nd question for you ever so knowledgeable gentlemen
I'm going to be refitting my Jet leg shields and rear runners in the not so distant future.
When I removed them I had an assortment of fasteners holding them down every one had a
finishing washer with a either a pan head, Slotted countersunk flat head, slotted countersunk oval head
or a Philips oval countersunk.
I've been looking for a list of what goes where and what was originally used.
I think I need 12 finishing washers 12 x countersunk and 8 x slotted pan head
Are the Countersunk screws Slotted or Philips head, flat or oval ?
when I removed them, the Philips looks a little more corroded so could be older or just
of a shitty quality.
Does one of the shops sell a kit or do any of you guys know what's needed and where it goes?
Many Thanks
I'm going to be refitting my Jet leg shields and rear runners in the not so distant future.
When I removed them I had an assortment of fasteners holding them down every one had a
finishing washer with a either a pan head, Slotted countersunk flat head, slotted countersunk oval head
or a Philips oval countersunk.
I've been looking for a list of what goes where and what was originally used.
I think I need 12 finishing washers 12 x countersunk and 8 x slotted pan head
Are the Countersunk screws Slotted or Philips head, flat or oval ?
when I removed them, the Philips looks a little more corroded so could be older or just
of a shitty quality.
Does one of the shops sell a kit or do any of you guys know what's needed and where it goes?
Many Thanks