Jet 200 leg shield hardware

Anything related to Lambrettas... ask tech questions, post helpful info, or just read and learn.
RBG
registered user
Posts: 202
Joined: Thu Jan 08, 2009 12:33 pm
Contact:

I've a 2nd question for you ever so knowledgeable gentlemen

I'm going to be refitting my Jet leg shields and rear runners in the not so distant future.
When I removed them I had an assortment of fasteners holding them down every one had a
finishing washer with a either a pan head, Slotted countersunk flat head, slotted countersunk oval head
or a Philips oval countersunk.

I've been looking for a list of what goes where and what was originally used.

I think I need 12 finishing washers 12 x countersunk and 8 x slotted pan head

Are the Countersunk screws Slotted or Philips head, flat or oval ?
when I removed them, the Philips looks a little more corroded so could be older or just
of a shitty quality.

Does one of the shops sell a kit or do any of you guys know what's needed and where it goes?

Many Thanks
User avatar
HxPaul
registered user
Posts: 1110
Joined: Fri Dec 06, 2013 1:58 pm
Main scooter: lambretta Li 150
Location: Halifax,Yorkshire
Contact:

If yours is the model with legshield runners and not mats,you can buy a complete runner fastener kit with all the correct bolts,nuts and washers.
RBG
registered user
Posts: 202
Joined: Thu Jan 08, 2009 12:33 pm
Contact:

It's got the Mats
It may yet get some holes drilled a set of scootopia runners, rubbers and a hardware kit if I have no luck.
buzzsolomoto
Dealer
Posts: 16
Joined: Sun Oct 16, 2011 10:23 pm
Main scooter: Jet 200 p200e
Location: Halifax
Contact:

phillips are original on Spanish scoots
RBG
registered user
Posts: 202
Joined: Thu Jan 08, 2009 12:33 pm
Contact:

buzzsolomoto wrote:phillips are original on Spanish scoots
Many Thanks for the info.
Post Reply Previous topicNext topic
  • Information
  • Who is online

    Users browsing this forum: Majestic-12 [Bot] and 12 guests