Cylinder Cowl Spacers?

[Leo]

I might be imagining this but I am sure I have seen some laser cut spacers that go between the mag flange and the cylinder cowl when you fit a longer rod crank?

If they do exist, anyone know who sells them?

[Darrell Taylor]

i have 5 and 10 mm available

[10 inch Terror]

viewtopic.php?f=7&t=36747

I made my own.

[Darrell Taylor]

viewtopic.php?f=7&t=36747

I made my own.

tidy work 10 inch
first one i did was hand cut then i got fed up of cutting and filing them and sourcing material so have them all water jet cut for my builds £8 -£10 at the material thickness i use ,, similar to an hours pay at minimum/average wage

[10 inch Terror]

viewtopic.php?f=7&t=36747

I made my own.

tidy work 10 inch
first one i did was hand cut then i got fed up of cutting and filing them and sourcing material so have them all water jet cut for my builds £8 -£10 at the material thickness i use ,, similar to an hours pay at minimum/average wage

To be honest for that money I'd buy rather than make one. I did try to buy one but couldn't get a reply from the people I asked.

[Darrell Taylor]

apologies if it was me ??? i do get busy spells and miss some messages

[Leo]

apologies if it was me ??? i do get busy spells and miss some messages

Ive just messaged you on Facebook about some spacers

[Darrell Taylor]

reply sent Leo

[Leo]

thanks