Hello all
I haven't done this for years and apologies if it's been covered . I'm want to fit a new 22mm scootopia carb to replace my worn 20mm dellorto I have the relevant 150 spacing inlet manifold the bike is a series 2 li 125 with a TV 175 series 2 barrel any suggestions on how to swap the manifolds over without dropping the engine , will there be enough room to pivot engine with rear wheel and shocker removed. I can't remember how to do it lol !! . Any suggestions would be greatly appreciated
Lambretta inlet manifold removal series 2
-
bristolmod
- registered user
- Posts: 1741
- Joined: Wed Jan 07, 2009 8:42 am
- Main scooter: Lambretta TV175 S3- what else!
- Location: Bali-Hai bar, Locarno Ballroom Bristol, 1967!- mines a Brown Split!!
- Contact:
remove rubber bump stop; remove rear shocker; undo the large nut and small ones holding head cowling on; remove spark plug.
That should give you enough room to get an 11mm socket on the two nuts.
That should give you enough room to get an 11mm socket on the two nuts.
Scootering since 1968.