Tiny wheel wobble.......
-
- registered user
- Posts: 960
- Joined: Fri May 23, 2014 6:54 pm
- Main scooter: Lambretta GP SS250 Casa
- Contact:
My back wheel on me TS1 GP has a tiny bit of movement, a bit of a wobble. I have tried different hubs, cones, everything but can't get rid. The shaft itself is solid, gearbox all shimmed up proper. Any thought MUCH appreciated as it is doing my head in!
Lambretta Series 2 Rat - RB260, SuperTourer, Cyclone 5 gearbox ππ
-
- registered user
- Posts: 960
- Joined: Fri May 23, 2014 6:54 pm
- Main scooter: Lambretta GP SS250 Casa
- Contact:
Not what I mean. When I grab the rear wheel and give it a shake, there is a tiny wobblemick1 wrote:Could be an un-even tread on the tyre......try a different tyre
Lambretta Series 2 Rat - RB260, SuperTourer, Cyclone 5 gearbox ππ
-
- registered user
- Posts: 796
- Joined: Sat May 28, 2016 4:51 pm
- Main scooter: Lambretta LI 125 S3
- Location: Skaville
- Contact:
Worn hub bearing, easy enough to change.
yes and noScooterdude wrote:Worn hub bearing, easy enough to change.
to get everything correctly shimmed in the gearbox you will need to have the side casing of and strup the clutch endplate lay shaft gears then the bearing and then put it all back and check the end float
We sleep soundly in our beds because rough men stand ready in the night to visit violence on those who would do us harm
-
- registered user
- Posts: 960
- Joined: Fri May 23, 2014 6:54 pm
- Main scooter: Lambretta GP SS250 Casa
- Contact:
Brand new hub bearing (Casa) was doing it before I changed bearing and still doing it! Engine has had all new bearings, new endplate, brand new close ratio gearbox, new clutch, the works. The only thing that has never been changed is the layshaft. Maybe it is worn but I can't see anything obvious. The splines all look good, can't see any obvious signs of wearScooterdude wrote:Worn hub bearing, easy enough to change.
Lambretta Series 2 Rat - RB260, SuperTourer, Cyclone 5 gearbox ππ
Does it still do it after a reasonable run as it might be the clearance in the bearing
We sleep soundly in our beds because rough men stand ready in the night to visit violence on those who would do us harm
-
- registered user
- Posts: 960
- Joined: Fri May 23, 2014 6:54 pm
- Main scooter: Lambretta GP SS250 Casa
- Contact:
Handles fine, no problems at allmick1 wrote:there is a "tiny" wobble on the wheel/hub anyway. How does it handle ?
Lambretta Series 2 Rat - RB260, SuperTourer, Cyclone 5 gearbox ππ
-
- registered user
- Posts: 960
- Joined: Fri May 23, 2014 6:54 pm
- Main scooter: Lambretta GP SS250 Casa
- Contact:
I'll check when I get in after tonight's spinshocky wrote:Does it still do it after a reasonable run as it might be the clearance in the bearing
Lambretta Series 2 Rat - RB260, SuperTourer, Cyclone 5 gearbox ππ