Drive side seal not air tight
- carlos fandango
- registered user
- Posts: 792
- Joined: Wed Jan 07, 2009 12:51 am
- Location: Stourbridge
- Contact:
How much air / pressure are you pumping in ? It should only be about 8psi , too much pressure and any seal will leak .
When i was young my Mom said "if you haven't got anything nice to say, say nothing at all " ..................... and people wonder why I'm quiet around them !
-
- registered user
- Posts: 960
- Joined: Fri May 23, 2014 6:54 pm
- Main scooter: Lambretta GP SS250 Casa
- Contact:
6 psicarlos fandango wrote:How much air / pressure are you pumping in ? It should only be about 8psi , too much pressure and any seal will leak .
Lambretta Series 2 Rat - RB260, SuperTourer, Cyclone 5 gearbox 😎👍
-
- registered user
- Posts: 960
- Joined: Fri May 23, 2014 6:54 pm
- Main scooter: Lambretta GP SS250 Casa
- Contact:
Hallelujah!!! She is air tight
Replaced the seal and the hallite washer bit, found I tiny leak on the inlet manifold sealed her all up and happy flippin days, the dial ain't moving at all. Only took three days!!!! I have never bothered leak testing before and have learnt the hard way with seizes and holed Pistons. So, not saying it will never happen again but at least I have learnt a little more about engine building and that can only be a good thing. Thanks again for all the help on here
Replaced the seal and the hallite washer bit, found I tiny leak on the inlet manifold sealed her all up and happy flippin days, the dial ain't moving at all. Only took three days!!!! I have never bothered leak testing before and have learnt the hard way with seizes and holed Pistons. So, not saying it will never happen again but at least I have learnt a little more about engine building and that can only be a good thing. Thanks again for all the help on here
Lambretta Series 2 Rat - RB260, SuperTourer, Cyclone 5 gearbox 😎👍
Make sure you smear a tad of grease round inside of seal, so it slips over crankshaft easily
they can get folded if not
Martin
they can get folded if not
Martin