hi
i have a sr 175 barrel but want to take it out to use a dt175 piston, will the barrel happily overbore to take this piston, which i believe starts at 66mm, is a iron tv175 barrel a better bet?
SR\175- 185 barrels
-
- registered user
- Posts: 214
- Joined: Fri Feb 19, 2010 5:33 pm
- Contact:
-
- registered user
- Posts: 650
- Joined: Sat Nov 24, 2012 7:59 am
- Main scooter: Gori200, rt195, ld150,rb20
- Location: Bakersfield, CA
- Contact:
id bet it will be a little thin on either cylinder. If you measure the OD of the cylinder sleeve at the base you can do the math and see how much room you have to play with.
-
- registered user
- Posts: 1741
- Joined: Wed Jan 07, 2009 8:42 am
- Main scooter: Lambretta TV175 S3- what else!
- Location: Bali-Hai bar, Locarno Ballroom Bristol, 1967!- mines a Brown Split!!
- Contact:
I've used iron TV175 cylinders taken out to 64mm with an appropriate piston with very good results.
Chris
Chris
Scootering since 1968.
- EddieStone
- registered user
- Posts: 432
- Joined: Mon Aug 17, 2015 4:13 pm
- Main scooter: Lambretta Li 150
- Contact:
Can you still buy iron TV175 cylinders?