I saw loads of posts before on the lcgb site, any good advice on what to run a front and rear tyre pressure at. I have sip stainless rims fitted with conti tyres. Also have a spare scootrs tubeless rim fitted with a schwalbe weatherman (changed to sips because rims seem a million times better and worried about schwalbe horror stories), if I every need to use the scootrs spare does anyone know if it will fit the s stud and nut combination? Or would I need to use different nuts, install the old studs in the hub?
Sent from basel using my pornpad
Sip tubeless tyre pressures?
I tend to run 20 - 24 psi front & 30 - 36 psi rear on my SIP rims. (Sava front, Conti rear at present)
If you're using the nuts that came with the rims then the easiest thing to do is carry a set of M8 nylocs for use with the spare.
I wouldn't want to be messing about changing studs at the side of the road!
If you're using the nuts that came with the rims then the easiest thing to do is carry a set of M8 nylocs for use with the spare.
I wouldn't want to be messing about changing studs at the side of the road!