I'd try a Dellortocorrado wrote:I'd try a smaller pilot jet.
Avanti set up
-
drunkmunkey6969
- Moderator
- Posts: 2838
- Joined: Sun Jan 04, 2009 1:42 pm
- Main scooter: '69 Lambretta GP
- Location: North Yorkshire
- Contact:
See our YouTube scooter channel for Tech-help: https://www.youtube.com/c/TheScooterFactory/videos
-
drunkmunkey6969
- Moderator
- Posts: 2838
- Joined: Sun Jan 04, 2009 1:42 pm
- Main scooter: '69 Lambretta GP
- Location: North Yorkshire
- Contact:
I refuse any Dyno work with these carbs fitted. I don't like them at all.SpanishSX200 wrote:......everything fell apart at the same time. Plating of the slide, jets with pieces falling off, needle worn to not a lot...,.
See our YouTube scooter channel for Tech-help: https://www.youtube.com/c/TheScooterFactory/videos
I was trying to be diplomatic Dan, but ditto
-
dapper
- registered user
- Posts: 930
- Joined: Tue Jan 27, 2009 5:30 pm
- Main scooter: The Biriani Bullet
- Location: Brighton (well Hove actually)
- Contact:
Ron, no offence meant at all. Wasn't calling your advice into question and I did state that the advice you gave me was from someone who was running a similar carb but did not state that you had set it up. I have good friends who swear by Dellies,, but I have never worked on or used one. I was given the OKO by a mate (who swears by Dellies 
) who didn't like it and I did all the mods to try to make it run ok cus I'm tight 
I'll see how things go and report back 
) who didn't like it and I did all the mods to try to make it run ok cus I'm tight I'll see how things go and report back Compact Toolbox Flywheel Holder