Which pistonm in 71mm clears the boost port on a TS1
- Powolotti
- Dealer
- Posts: 103
- Joined: Wed Jan 07, 2009 2:53 pm
- Location: 40 miles north of Vienna
- Contact:
I will check this and let you know, I know a few lads running this piston and they say it fits without repegging. WCLW site says lower peg is inside the boost port, but I´m quite sure I saw a picture on GSF showing this is not the case with unmodified (widenend) ports. Get back to you soon...
meet me on Facebook: Michael Powolotti
some of my tuning work:
http://www.facebook.com/pages/Powolotti ... 6938811863
my club:
http://www.wiener-spitzbuam.at
some of my tuning work:
http://www.facebook.com/pages/Powolotti ... 6938811863
my club:
http://www.wiener-spitzbuam.at
How much is a new genuine H2 750 71mm piston complete with rings worth these days? anyone know
-
- registered user
- Posts: 298
- Joined: Wed Jan 07, 2009 7:19 pm
- Location: Cheam, Surrey
- Contact:
good idea
presume that best to do this on a wire ring only, moving the ring round like that
what did you use to cut the notch, rather do it right
presume that best to do this on a wire ring only, moving the ring round like that
what did you use to cut the notch, rather do it right
- byron
- registered user
- Posts: 1226
- Joined: Wed Jan 07, 2009 11:45 am
- Main scooter: Li Special; scarred,but sound
- Location: norwich
- Contact:
nice solutionAdspeed wrote:... the peg was not moved just moved ring round......this pic is after 2 years of hurtlin about.......This year will be its fourth year and now issues. .
If its any help, I have been using Adspeed's solution in my sprinter for some time now.
Not had any ring failures - famous last words....
Mind I'm running at 100mph + at the end of the quarter mile so I reckon you'd be OK with this solution!
Mr Tucky
Not had any ring failures - famous last words....
Mind I'm running at 100mph + at the end of the quarter mile so I reckon you'd be OK with this solution!
Mr Tucky
-
- registered user
- Posts: 298
- Joined: Wed Jan 07, 2009 7:19 pm
- Location: Cheam, Surrey
- Contact:
What piston and barrell are you using if you dont mind me askingKen Tucky wrote:If its any help, I have been using Adspeed's solution in my sprinter for some time now.
Not had any ring failures - famous last words....
Mind I'm running at 100mph + at the end of the quarter mile so I reckon you'd be OK with this solution!
Mr Tucky
No problemo David.
Piston is 71.00 Wiseco Yamaha YZ 250 G,H,J 1980 -1982
Barrel is TS1
Hope this is of some help.
Mr Tucky
Piston is 71.00 Wiseco Yamaha YZ 250 G,H,J 1980 -1982
Barrel is TS1
Hope this is of some help.
Mr Tucky