Dellorto needle advice

[djh66]

Is a X13 needle richer than a X7? Cheers Dave

[djh66]

Anyone?

[col68]

yes mate :fb:

[wack 63]

Only richer as it gets on to the taper earlier,the 1/4 throttle position is still the same (2.5mm) http://www.dellorto.co.uk/images/parts/ ... charts.pdf

[DaveTomo]

Leanest - X12 - X7 - X13 - X2 - X25 - X10 - X16 - X32 - Richest

[Daggs]

Leanest - X12 - X7 - X13 - X2 - X25 - X10 - X16 - X32 - Richest

Hmmmm ! That's a nice logical sequence. Thanks Dellorto...............................................

[Special X]

Only richer as it gets on to the taper earlier,the 1/4 throttle position is still the same (2.5mm) http://www.dellorto.co.uk/images/parts/ ... charts.pdf

My scoot when fitted with an X7 is rich at 1/4 throttle and pinks at 1/3 - 1/2 throttle. An X13 cures the pinking but is still rich at 1/4 throttle. I'm on an AV266 I'm going to try using an AV264 and moving the X13 1 clip richer to see if I can get it right.

So yes an X7 is weaker at least to 1/2 throttle but stays rich at the bottom end.

[jonny snatchsniffer]

fit a weaker slide if yr rich up to 1/4

[Special X]

Already on a 45 - anyone reckon I dare fit a 50? It's ok on tickover, ok on progression (up to just over 1/8 throttle) massively rich at just under 1/4 throttle to just under 1/3 throttle then OK all the way up (needle at 1st clip)

With an X7 it's the same but pinking in the mid throttle positions. Choke is deffo not leaking.

[jonny snatchsniffer]

yeah id fit a 50, or if you have a spare slide file it till u get the desired effect