What's the best way to wire up a full DC system that will turn off completely when in the off position on the switch?
I want to power the MB speedo from the ignition as well.
The only way I can see with the ignition switch I've got (P 0 1 2 3 ) is to run the lights off the black which powers the speedo bulb and rear lights in the P, 2 and 3 positions
Am I missing or over looking something?
DC Ignition switch wiring
- soulsurfer
- registered user
- Posts: 2539
- Joined: Thu Jan 08, 2009 2:43 pm
- Location: The Garden Of England
- Contact:
I always run with lights anyway so set all gauges to position 2, pilot and rear light.
Turn On, Tune In, Cop out!
I always ride with the lights on as well, so never really use position 1 anyway.
Just wanted to check I wasn't over looking anything before I make the loom.
Just wanted to check I wasn't over looking anything before I make the loom.