fuel gauge senders to fit in a lammy tank
- Monty
- registered user
- Posts: 472
- Joined: Wed Jan 07, 2009 7:21 pm
- Main scooter: Series 1 Muggy, Imola Special
- Location: STOCKPORT
- Contact:
I picked up a Kawasaki GPX600 sender off ebay for 5quid
My tank is a remade one without baffles so loads of room
a 25mm hole just to the side of the strap with 4 clench nuts, bolts it to the top of the tank. The float arm runs across the tank. I do like the one mark has done, very neat and will work with baffles.
I did have to change round the wire wound resistor as the gauge needed 0 Ohms to show full. It originally was O for empty 100 Ohms full.
My tank is a remade one without baffles so loads of room
a 25mm hole just to the side of the strap with 4 clench nuts, bolts it to the top of the tank. The float arm runs across the tank. I do like the one mark has done, very neat and will work with baffles.
I did have to change round the wire wound resistor as the gauge needed 0 Ohms to show full. It originally was O for empty 100 Ohms full.