Hi all, can anyone tell me if these conversions are worth doing now that you can buy Xenon type bulbs for standard Lammy headlight holders. Only i knocked up an H4 conversion a few years back and wondered if it was worth fitting. I'll post some pictures and would be grateful if anyone could tell me if what i have will work or if i need to do anything else to it. Cheers Pete
H4 headlight conversion
-
- registered user
- Posts: 1447
- Joined: Tue Jun 29, 2010 9:17 pm
- Xbox live gamer tag: No.
- Playstation gamer tag: PLEASE!
- Main scooter: Lambretta LI Imola 185
- Location: Farnborough Hampshire
- Contact:
- Speed Demon
- Dealer
- Posts: 392
- Joined: Mon Feb 02, 2009 12:09 pm
- Contact:
IMHO this solution is lots better than any of the conversion bulbs I've tried.
Get to SULK
- wack 63
- registered user
- Posts: 1254
- Joined: Fri Nov 27, 2009 9:33 pm
- Main scooter: '71 GP TS1
- Location: Lincs
- Contact:
They work fine you just have to get the focal point set right to get a good beam.I think the bulbs casing needs to protrude around 5mm forward of the original holder.I usually take the headlight off,wire up to a battery,fit the holder then play about with focal settings till it gives a good beam on a wall before finally fitting to scoot.
-
- registered user
- Posts: 1447
- Joined: Tue Jun 29, 2010 9:17 pm
- Xbox live gamer tag: No.
- Playstation gamer tag: PLEASE!
- Main scooter: Lambretta LI Imola 185
- Location: Farnborough Hampshire
- Contact:
Si can basically fit it as it is or do i need anything else? Thanks for your comments sp far. Pete
- soulsurfer
- registered user
- Posts: 2539
- Joined: Thu Jan 08, 2009 2:43 pm
- Location: The Garden Of England
- Contact:
Sticky, did you ever try this on Varitronic?Speed Demon wrote:IMHO this solution is lots better than any of the conversion bulbs I've tried.
Turn On, Tune In, Cop out!