Chopper switches

[wack 63]

Is there a particular switch that builders are using on chops etc with steel bars? I'm looking for something small with dip/high, horn and possibly kill to go with a MB gearchange which will look odd I think but r/hand side has throttle and master cylinder.

[mark]

i didnt use a handlebar switch on pride because i wanted it to be a clean look,i put a toggle switch in the bottom of the bates headlamp shell for hi/lo.i always intended to put a ignition switch in rear leccy box nbut never got round to it. my lights were on all time engine was running and i stalled it to stop it lol.

[joey]

hey wack what about this...?



it's a genuine nos servetta switch that fits into a m/c switch housing....
i was going to use it about 25 years ago on a cut down[when cut downs were the height of fashion] but ended up rewiring a m/c switch....

merry christmas all...!

[newmanlammy]

Vehicle wiring products have anice range and good prices

http://www.vehicle-wiring-products.eu/V ... itches.php

[wack 63]

Thanks for the info chaps ,think I may have found one on Ebay that looks ok http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... K:MEWAX:IT

[wack 63]

This looks a nice bit of kit but very expensive http://www.streetchopperweb.com/hotnews ... to_02.html

[GTFOMWSC]

i used a beedspeed universal one on mine does the job just fine hi/lo,kill,horn,on and off cost about £13 plus p&p i think.