Help please,
When attaching my carb (sh1/18 dellorto) I cant get to sit tight on the manifold, no matter how tight the clamp is I still get some side to side movement, enought for it to slip off.
Is this normal? its a new manifold so that should be OK, and I replaced the clamp (which is the correct size (18m), and still no joy (i cant remember of it was tight when taking off )
is there some sort of sealant I can use so it sits tightly ? I replaced the plastic sleeve as well in the carb.
Any ideas would be appreciated ......
Carb to inlet manifold
-
- registered user
- Posts: 40
- Joined: Wed Feb 17, 2010 9:59 pm
- Location: Leeds, West Yorkshire
- Contact:
The nylon bush that sits in the back of the carb body must be worn, you should be able to get a replacement bush that will sort it.