Carb to inlet manifold

Anything related to Lambrettas... ask tech questions, post helpful info, or just read and learn.
andy summers
registered user
Posts: 41
Joined: Wed Feb 17, 2010 9:59 pm
Location: Leeds, West Yorkshire
Contact:

Mon May 17, 2010 2:46 pm

Help please,

When attaching my carb (sh1/18 dellorto) I cant get to sit tight on the manifold, no matter how tight the clamp is I still get some side to side movement, enought for it to slip off.

Is this normal? its a new manifold so that should be OK, and I replaced the clamp (which is the correct size (18m), and still no joy (i cant remember of it was tight when taking off :oops: )

is there some sort of sealant I can use so it sits tightly ? I replaced the plastic sleeve as well in the carb.

Any ideas would be appreciated ......

J1MS
registered user
Posts: 1159
Joined: Sat Jan 10, 2009 12:02 am
Contact:

Mon May 17, 2010 3:10 pm

The nylon bush that sits in the back of the carb body must be worn, you should be able to get a replacement bush that will sort it.

User avatar
rog60
registered user
Posts: 596
Joined: Fri Feb 13, 2009 7:18 pm
ebay user ID: scootrogcat
Main scooter: Indian GP200
Location: SWINDON (Wilts)
Contact:

Mon May 17, 2010 9:23 pm

Could also be wear on the inlet stub of the manifold............have a look at the underside of the stub.
NO IT'S NOT A F***IN* MOPED!!!!!!

Post Reply Previous topicNext topic
  • Information
  • Who is online

    Users browsing this forum: No registered users and 12 guests