Speedo Drive Wheel Fitting

Anything related to Lambrettas... ask tech questions, post helpful info, or just read and learn.
registered user
Posts: 159
Joined: Thu Feb 26, 2015 1:29 pm
Main scooter: Lambretta S3 Li150
Location: Coventry

Tue Feb 13, 2018 10:29 am

Just about ready to begin the assembly of the front hub. Managed to get the old speedo drive off as suggested in Stick's. Is there a tried and tested method of fitting the speedo drive wheel? Is it best pressed on with a vice or tapped on with mallet and block of wood?. Should I grease it prior to fitting? Just for info it is the metal type from MB

User avatar
registered user
Posts: 186
Joined: Thu Apr 30, 2009 8:30 pm

Tue Feb 13, 2018 1:09 pm

Putting it in hot water prior to fitting seems to be one of the methods suggested, I think it states this in Stickys manual ;)
Last edited by db67 on Tue Feb 13, 2018 8:50 pm, edited 1 time in total.

registered user
Posts: 1375
Joined: Thu Sep 16, 2010 9:54 pm
Main scooter: SX 150 running in

Tue Feb 13, 2018 1:10 pm

I used a flat block of wood and a neoprene mallet after heating in hot water
im not a complete idiot
s me of the piec s are mis i g

Post Reply Previous topicNext topic
  • Information
  • Who is online

    Users browsing this forum: No registered users and 17 guests