Spanish ser 2 mudguard
The rear muddy on my Spanish Li S2 has two large holes (approx 10mm) punched into the rear lower edge. Because they are punched not drilled, I'm assuming they are factory created. Does anyone know why they are there?
They're to fit the rubber buffer (square black rubber block) that fits between the mudguard and the frame between the two panel bracketsDaggs wrote:The rear muddy on my Spanish Li S2 has two large holes (approx 10mm) punched into the rear lower edge. Because they are punched not drilled, I'm assuming they are factory created. Does anyone know why they are there?
Cheers whonatic. Fairly obvious when I think about it, doh!
It's only obvious when you know itDaggs wrote:Cheers whonatic. Fairly obvious when I think about it, doh!
-
charlton_supporter
- registered user
- Posts: 25
- Joined: Sun May 13, 2012 11:01 pm
- Main scooter: LI150 Special
- Location: Hatfield
- Contact:
Any pictures available?
Sent from my SM-N910F using Tapatalk
Sent from my SM-N910F using Tapatalk
Available from Scootopia
-
charlton_supporter
- registered user
- Posts: 25
- Joined: Sun May 13, 2012 11:01 pm
- Main scooter: LI150 Special
- Location: Hatfield
- Contact:
Thanks for that.kevspeed wrote:
Available from Scootopia
Sent from my SM-N910F using Tapatalk