Replacement CASA 185 kit piston
-
- registered user
- Posts: 960
- Joined: Fri May 23, 2014 6:54 pm
- Main scooter: Lambretta GP SS250 Casa
- Contact:
If I were to replace the piston on a CASA 185 kit, would I HAVE to buy a CASA replacement piston or would I be able to use any 185 64mm piston. I have seen some great pistons at about half the price Thanks in advance!
Lambretta Series 2 Rat - RB260, SuperTourer, Cyclone 5 gearbox 😎👍
-
- registered user
- Posts: 673
- Joined: Wed Feb 01, 2012 2:00 pm
- Main scooter: Li230 S3
- Location: Perth, Western Australia
- Contact:
There is a "boost port" type hole in the side of the piston AFAIK, so I think it would have to be the genuine article.
http://www.torbaylambretta.co.uk/Casa_1 ... 77500.aspx
http://www.torbaylambretta.co.uk/Casa_1 ... 77500.aspx
-
- registered user
- Posts: 960
- Joined: Fri May 23, 2014 6:54 pm
- Main scooter: Lambretta GP SS250 Casa
- Contact:
Yes I see it, I have found one at Rimini Scooter Centre for £87 so not too badMinority wrote:There is a "boost port" type hole in the side of the piston AFAIK, so I think it would have to be the genuine article.
http://www.torbaylambretta.co.uk/Casa_1 ... 77500.aspx
Lambretta Series 2 Rat - RB260, SuperTourer, Cyclone 5 gearbox 😎👍
- corrado
- Dealer
- Posts: 2588
- Joined: Thu Jan 08, 2009 1:12 am
- Main scooter: Lambretta GP
- Location: Top of Blackpool Tower
- Contact:
I've been looking at that too, as I want to keep to a TV crank on my TV175. I've got a Mitaka piston but not sure that the position of the rings will allow me to use it in the casa barrel as the rings get a bit too close to the boost port.