To rub down or not????
Posted: Sun Apr 30, 2017 2:31 pm
Just sprayed a couple of bits with a rattle can and to be honest I'm quite pleased with the result. It's quite a shiny finish but the only problem is there are a few "blemishes" possibly where a bit of dust has been sprayed over etc. My dilemma is do I leave it and not stand the chance of ballsing it all up or is there a way of gently removing them and flattening it then getting the finish back to a nice shine? Can I rub them down with some very fine wet wet and dry and then polish with compound then t cut then polish and get a decent result? Any advice would be very helpful