lambretta frame jig work
- garry inglis
- registered user
- Posts: 1298
- Joined: Tue Jul 21, 2015 8:04 pm
- Main scooter: ts1 230 and rb200
- Location: darlington
- Contact:
that's a measure twice cut once if ever ive seen one
-
- registered user
- Posts: 436
- Joined: Sun Oct 17, 2010 5:31 pm
- Main scooter: lambretta ld auto
- Contact:
Hi.i have a series 1 frame so could measure this for you?Robi D wrote:Do you have any rough dimensions for series 1/2 frames? I have to replace the centre stand strut on my ser 2 and my legshields are a bit wavy yet to try and sort it that way. I'd rather some kind of dimensions. I'm a welder fitter by trade amd set in my ways!! Lots of info out there for ser 3 but not much for 1/2. I'm not sure of the placement of my rear hanger either. It looks good until the bottom where it's pressed together. I think it might be bent in towards the frame tube.
Thanks