Scooterotica

went out for a little ride the other night, took a pic


[imgIMG_0584_zpsgbdkwd1c by stephen holt, on Flickr][/img]

did scarborough scooter rally, there and back on friday and saturday , no breakdowns for me, ran well.


[img17861540_10154677569709755_9090254142804420348_n_zps19v1qqdt by stephen holt, on Flickr][/img]

[img17952589_10154677569684755_325652446153381631_n_zpsmfxc12yk by stephen holt, on Flickr][/img]

cleethorpes 2017, a realy nice day, scooter ran very well, got a little warm on the way home but was fine, it was a very hot day
IMG_0985 by stephen holt, on Flickr

outside an old garage a few miles away from me.
IMG_1093 by stephen holt, on Flickr

Still looks good holty are you going to breighton tommorw how about Gav have you heard from him

IMG_1101 by stephen holt, on Flickr

Hi holty you no we were on about air leeks well I made some plywood plates to fit the crankcase on that 200 casing that leaked and fit gasket underneath and grease and put more jb weld over the porous welds and let it harden for a couple off days then put 4psi in and no air leeks well a bit out of the piece I put in the main bearing hole but ok I just thought I would test the casing

Sent from my SM-A320FL using Tapatalk

good work garry, i know some people frown about using jb weld, but others swear by it, ive filled a couple of voids in my rotax conversion with it, i will leak test that when its assembled, im just playing with the exhaust at the moment, it driving me crazy, i will have another go at it tonight i think.

went to a local rally a few weeks ago, took a picture while there
Untitled by stephen holt, on Flickr

garry inglis wrote: ↑Fri Aug 11, 2017 3:55 pm Hi holty you no we were on about air leeks well I made some plywood plates to fit the crankcase on that 200 casing that leaked and fit gasket underneath and grease and put more jb weld over the porous welds and let it harden for a couple off days then put 4psi in and no air leeks well a bit out of the piece I put in the main bearing hole but ok I just thought I would test the casing

Sent from my SM-A320FL using Tapatalk

Jesus!! Who welded that Stevie Wonder? No seriously that bloke from oiltek should have made some blanking plates like that, would have saved himself and customers a whole load of hastle...just saying.