Lambretta stainless stand

If you want to tell us about or ask about a standard spec or restoration project....post it here.
Mrnice71
registered user
Posts: 29
Joined: Tue Jul 11, 2017 9:41 pm
ebay user ID: lambrettas11
Main scooter: Lambretta series 3
Contact:

Thu Dec 21, 2017 7:59 pm

Hi , guys
Looking to purchase a stainless steel stand for a series 3 , lve read some are too tall making front wheel airborne and others have the brackets welded in the vertical position which makes the scooter prone to coming off stand . Any recommendations on who sells the best ones out there please ...thanks .

sparklymarkly
registered user
Posts: 336
Joined: Wed Jan 04, 2012 6:33 pm
Main scooter: Lambretta GP
Contact:

Thu Dec 21, 2017 9:34 pm

Just Lambretta (Corrado on here) does a good one.

Mrnice71
registered user
Posts: 29
Joined: Tue Jul 11, 2017 9:41 pm
ebay user ID: lambrettas11
Main scooter: Lambretta series 3
Contact:

Thu Dec 21, 2017 9:54 pm

sparklymarkly wrote:
Thu Dec 21, 2017 9:34 pm
Just Lambretta (Corrado on here) does a good one.
Looked on his site but none on there :(

hendy
registered user
Posts: 718
Joined: Mon Jul 07, 2014 10:34 am
Main scooter: lambretta li 125
Location: Tyne and Wear
Contact:

Fri Dec 22, 2017 8:55 am

I bought a tsr one. Pretty good but definitely not perfect. It needed around 40mm taking off each leg and i had to use aluminium feet as the rubber ones wouldn't stay in place because there was no hole for the pin.

Mrnice71
registered user
Posts: 29
Joined: Tue Jul 11, 2017 9:41 pm
ebay user ID: lambrettas11
Main scooter: Lambretta series 3
Contact:

Fri Dec 22, 2017 3:52 pm

hendy wrote:
Fri Dec 22, 2017 8:55 am
I bought a tsr one. Pretty good but definitely not perfect. It needed around 40mm taking off each leg and i had to use aluminium feet as the rubber ones wouldn't stay in place because there was no hole for the pin.
Looking for one l don't have to mess with hendy , heard some are very hard to drill

hendy
registered user
Posts: 718
Joined: Mon Jul 07, 2014 10:34 am
Main scooter: lambretta li 125
Location: Tyne and Wear
Contact:

Fri Dec 22, 2017 3:57 pm

Mrnice71 wrote:
Fri Dec 22, 2017 3:52 pm
hendy wrote:
Fri Dec 22, 2017 8:55 am
I bought a tsr one. Pretty good but definitely not perfect. It needed around 40mm taking off each leg and i had to use aluminium feet as the rubber ones wouldn't stay in place because there was no hole for the pin.
Looking for one l don't have to mess with hendy , heard some are very hard to drill
Correct. Unless you have access to a machine shop you have diddly squat chance of drilling stainless round bar. But if you're happy to use aluminium feet and have a cutting disc they're fine.

Post Reply Previous topicNext topic
  • Information
  • Who is online

    Users browsing this forum: No registered users and 2 guests