Had these on backburner for over 2 years finaly had time to get into production .
New billet hub " trad disc brake style "also for SIP rims
- frank sanderson
- Dealer
- Posts: 144
- Joined: Thu Jan 08, 2009 8:43 am
- Location: preston
- Contact:
i know a rather nice grp 6 race bike that would look cool with one of them ..want it testing
Its in bits scooter club: www.facebook.com/groups/132415046859320
- red
- registered user
- Posts: 637
- Joined: Thu Jan 15, 2009 8:40 pm
- Main scooter: Scomadi TL 250 (Ltd Ed No.3)
- Location: Blyton,Lincolnshire
- Contact:
On the beg again,can't fault ya this time tho'RICSPEED wrote:i know a rather nice grp 6 race bike that would look cool with one of them ..want it testing
I do not try to explain why I ride Lambrettas,
For those who understand, no explanation is necessary,
For those who don't, no explantion is possible.
For those who understand, no explanation is necessary,
For those who don't, no explantion is possible.
- Andy Pickering
- registered user
- Posts: 2172
- Joined: Sun Jan 25, 2009 10:15 pm
- Main scooter: GP
- Location: Hull
- Contact:
As always Frank a quality bit of kit from you and the PM boys, How much these going to retail at Frank.
Ricspeed, gone but never forgotten RIP my friend #59
it will in all honesty shred ya pads fast as fook ... but will stop on the dotcorrado wrote:I like the hub but not the "blingy" disc. Does that type of disc work better than a conventional round design?
Its in bits scooter club: www.facebook.com/groups/132415046859320
only difference at a glance is the centerpiece and anti dive
Its in bits scooter club: www.facebook.com/groups/132415046859320
Now that I Like!!!
Can the centre/hub be supplied powder coated or any reason why this couldn't be done once purchased? Looking to fit to a 60s race style bike and ideally want it white to mimic a standard disc....
Can the centre/hub be supplied powder coated or any reason why this couldn't be done once purchased? Looking to fit to a 60s race style bike and ideally want it white to mimic a standard disc....
i would say yes ....but .. surfaces where two parts meet would need masking just as you would for a case for instanceRich wrote:Now that I Like!!!
Can the centre/hub be supplied powder coated or any reason why this couldn't be done once purchased? Looking to fit to a 60s race style bike and ideally want it white to mimic a standard disc....
Its in bits scooter club: www.facebook.com/groups/132415046859320