Gorillaz's

[CANbus]

I was wondering if anyone had successfully modified or cut down the foam, on a filter like this to fit under the side panel? Or found a filter that will fit a 30mm VHSA?
Thanks.

[JINX]

Thanks for the reply on the bracket. It looks like I can figure it out from there. So simple, I love it when its basic and functional.

Have you considered a marchald filter?
http://jet200.com/catalog/product_info. ... cts_id=748

I would also consider attaching a rubber hose to the carb mouth and angling it rearwards so its nearly horizontal, then put the filter on the end of that. I used a thin walled aluminum tube to keep it rigid. The tip would have to end near the strut. Not alot of room you have to work with that huge tank.

[camel]

exellent bike....the seat is killing it though.....

[Bilko]

exellent bike....the seat is killing it though.....

I have to agree. The whole Lambretta is superb, I love it, except for the seat. A wee Ancilotti and it would be perfect

[Diablo]

The marchald filters I've seen on the dyno have been quite restrictive especially with the panel on as I think the front will still touch. The camlam breath sweet fit series 3s with MB manifolds but I'm not sure about on Rons kits.

[CANbus]

Added a motorbike GPS to Gorrilaz's, it goes great.
It can be operated wearing gloves, Bluetooth etc.
Cheap as well

[marktheskin]

where was that GPS from may i ask and how much?

[Toddy]

Added a motorbike GPS to Gorrilaz's, it goes great.
It can be operated wearing gloves, Bluetooth etc.
Cheap as well

Very nice

[CANbus]

I bought my GPS with maps included from a reseller. However it looks like you can them from the link pretty cheap but without the software.
The operating system is widows CE, the software required would be something like primo 2 iGO8, which is readily available off the internet.

I may get a HD camera from them next?


http://www.chinavasion.com/china/wholes ... _Navigator

[Fenian Mick]

looks great.........well done pal.