Page 1 of 2
Steviemonsters Lambretta
Posted: Tue Feb 24, 2009 4:57 pm
by sean brady scooters
Re: Steviemonsters Lambretta
Posted: Tue Feb 24, 2009 5:04 pm
by Knowledge
Nice machine. It would certainly get my attention sat amongst other scooters
Re: Steviemonsters Lambretta
Posted: Tue Feb 24, 2009 5:40 pm
by high plains.......
that looks great...i like it, lots
that style of seat looks great on it aswell
cheers
geoff
Re: Steviemonsters Lambretta
Posted: Tue Feb 24, 2009 7:23 pm
by Dryballs
Have you earthed the regulator somewhere else?
I wouldnt have thought the glovebox is earthed to the frame very well? Its rubber mounted isnt it?
Nice scoot by the way - He should take it with him!
Re: Steviemonsters Lambretta
Posted: Tue Feb 24, 2009 8:03 pm
by mark
toolbox earths thru 3 mounting bolts?
Re: Steviemonsters Lambretta
Posted: Tue Feb 24, 2009 8:05 pm
by markwh45
nice clean looking scoot
Re: Steviemonsters Lambretta
Posted: Tue Feb 24, 2009 8:11 pm
by byron
mark wrote:toolbox earths thru 3 mounting bolts?
I've got my electrics on a plate there and there wasn't a good enough earth through the toolbox. So I ran a wire from the engine to the common earth stud I'd made. but, then, I am a bit obsessive about earths.
oh, nice looking bike btw. the panel scoop is neat.
Re: Steviemonsters Lambretta
Posted: Tue Feb 24, 2009 10:44 pm
by Fireman Ash
Side panel carb inlet fabrication looks very tidy.
Whats the asking price likely to be or is that negotiable?
Great looking scoot and tidy engine job, exhaust looks great too..cool...NICE ONE!!
Re: Steviemonsters Lambretta
Posted: Wed Feb 25, 2009 12:50 pm
by sean brady scooters
regulator is earthed to the toolbox and the toolbox is earthed to the frame via another earth wire......nitpickers!..
.......the coil and regulator is wired there for ease...aesthetics and also so theres a more direct shorter distance to the sparkplug via the HT lead...........
Re: Steviemonsters Lambretta
Posted: Wed Feb 25, 2009 2:01 pm
by dapper
Nice scoot, Nice air scoop, but thought the gear/clutch cables should go under the engine mount