Search found 576 matches
- Thu Feb 11, 2010 12:57 am
- Forum: Lambretta Tech
- Topic: in one end out the other!
- Replies: 15
- Views: 4398
Re: in one end out the other!
I have been running a 24mm mikuni on my 225 rapido and on runs i would get 54mpg, now going RT255 and 28mm power jet keihin but with 18-46 and Li150 so high gearing should give me the same mpg, cruising at 80mph should only be 4000rpm ;) :lol: ;) Mazz (not sure if he is on here) was getting high 20...
- Thu Feb 11, 2010 12:33 am
- Forum: Lambretta Tech
- Topic: Complete Spanners Manual - corrections please
- Replies: 50
- Views: 14506
Re: Complete Spanners Manual - corrections please
The 1st edition is very clear on how to disemble and reassemble a series 3. It even has some detail on tuning and handlig upgrades. What I'd like advice on is preventing some knob bolting bloody chrome pipework to it!Anything on this in the new edition? :lol: Seconded! A center-spread health warnin...
- Wed Feb 10, 2010 11:54 pm
- Forum: Lambretta Tech
- Topic: in one end out the other!
- Replies: 15
- Views: 4398
Re: in one end out the other!
Not getting much better MPG than that on my Rapido (250). 'Planned' as a touring set-up (well exhaust and gearing at least, if not the tune and the carb), the thirst is a fly in the ointment. Think I'll swap the carb out and try a 28mm in place of the 34mm VHSB. I used to get decent MPG with a 28mm ...
- Sat Feb 06, 2010 10:23 pm
- Forum: Lambretta Tech
- Topic: New Casings always with Endplates?
- Replies: 17
- Views: 4815
Re: New Casings always with Endplates?
No, but you need to find an end plate that works with your case...that's all.... If you have noticed the Innocenti end plates all have a large reference number (part of the casting in a circle) on them. At least the earlier ones are. These are not just interchangeable! EG. Rebuilding a small block c...
- Sat Feb 06, 2010 10:01 pm
- Forum: Lambretta Tech
- Topic: kickstart s/2
- Replies: 10
- Views: 3142
Re: kickstart s/2
Yes: extended by approx 50mm to reach the rubber stop: easy weld job, but better done on an old lever/b4 choromin'Mel K wrote:Won't you also need a series 2 side casing? Or extend the bit that rests on the rubber stop?Jet200 wrote:Series 1/2 kickstart pedal so it clears the wider footboards
- Thu Jan 21, 2010 11:53 pm
- Forum: Lambretta Tech
- Topic: one for mr blythe ?
- Replies: 7
- Views: 2160
Re: one for mr blythe ?
Can 2 or 3 of these find their way round eg. a Chiselspeed (short) manifold and a VHSB?