Scooterotica

Mrnice71

Ok cheers guys

Mrnice71

Dont quite understand you there Paul ? Do you mean regulate the power coming from the CDI unit ?

Mrnice71

Do you run the Readspeed Lukas CDI with or without a voltage regulator on A/C ? Cheers

Mrnice71

l would speak to Mark as that bearing may use a different seal , the inner lip sits down and some hub bearings can have a sharp leading edge , also are you using seal grease on assembly as a seal fitted dry will quickly fail as the bearing goes tight once the seal is fitted

Mrnice71

Just because its pre-fitted doesn't mean its fitted correctly , buy a new seal & fit it yourself

Mrnice71

The MB hub bearings are known to be crap l would recommend RIV or Casa , what make of seal is it ? l only use Rolf , l can never even fit the pattern ones without damaging them and warm them up a bit when fitting and lots of seal grease

Mrnice71

l run a 3.50 mm float valve jet on a 30 mm dellorto flatslide , put the 3.00mm back in or you will have fuel starvation issues .
Air filters are restrictive which will richen up jetting , so try a 135 main jet , let us know how you get on .

Mrnice71

db67 .....a 200 float valve jet is to small , you need a 300 , what exhaust are you running ? On a standard TS1 a 140 main could be a bit to large

Mrnice71

Good thanks for letting us know , just shows cheap Indian seals are useless

Mrnice71

A 4 plate should be fine with that set up , the scootopia clutch plates are good with MB springs and rough the steel plates up a bit and putoline SAE 90 gear oil should hold

Search found 111 matches

Re: Readspeed Lukas CDI

Re: Readspeed Lukas CDI

Readspeed Lukas CDI

Re: Wits end ...and past it

Re: Wits end ...and past it

Re: Wits end ...and past it

Re: Jetting

Re: Jetting

Re: Rear hub oil seal

Re: rt 195

Login • Register

Advertising