Scooterotica

Boreham

Boreham wrote:Cheers Gary, just need to track down a U16 needle.

Dellorto UK, £10.34, cheers for the info!

Boreham

Cheers Gary, just need to track down a U16 needle.

Boreham

Thanks Gary, can i just confirm the atomiser is a DQ267, the AQ is listed for the smaller PHBL carbs?

Boreham

Tried several searches, anyone have a start point for this carb, the needle selection is endless!
TS1 with Franspeed race pipe.

Boreham

Hi Adam, I cannot comment on the specific DT kit however i have had a similar engine built by Pro porting, Monza barrel, 62x110 crank etc.... and the work involved to produce the quoted BHP was quite involved. The Monza barrel does have a similar port layout but the main comment i picked up by PP wa...

Boreham

I am runnung 2, from mid to full race tune, they are an amazing transformation.
The key is installing and setting up correctly, they get a bit of bad press but they are not a 'plug and play' if in doubt get a ptofessional to fit

Boreham

Hi Martin,
It sounds like you have the later shock with the integral thread, this has a rubber bush either side, the upper bush is a different shape, SIP part number 17185000
Cheers

Boreham

A useful site to calculate the combinations of PWK type jets and needles etc..
www.kyajet.com

Boreham

Hi,
I have ran a few on a Dellorto, usually a much richer needle X2 has been the key.
Cheers

Boreham

I just use the Dellorto PH ones, same thread!

Search found 102 matches

Re: TS1 & VHSH 30

Re: TS1 & VHSH 30

Re: TS1 & VHSH 30

TS1 & VHSH 30

Re: Ultimate Engine Spec - Based on New Casa Case

Re: 4 or 5 Speed Feedback So Far?

Re: Vespa small frame rear shock top mount

PWK jetting site

Re: TS1 200 carb advice needed

Re: 90 degree mikuni throttle cable elbow

Login • Register

Advertising