Search found 930 matches
- Mon Nov 23, 2015 11:37 am
- Forum: Lambretta Tech
- Topic: small block to large block conversion
- Replies: 20
- Views: 11955
Re: small block to large block conversion
I know Digger on here had a case done. Looked very well machined. They can add more meat around the transfers for tuning too. But you'll have to be patient as they're turnaround is quite long at the moment apparently.
- Tue Aug 04, 2015 5:15 pm
- Forum: Lambretta Tech
- Topic: sealing exhaust
- Replies: 5
- Views: 2365
Re: sealing exhaust
I always linnish the exhaust manifold on glass covered with wet 'n dry and also do the solid copper gasket (which I prefer) so that all surfaces are perfectly flat and then use Hi temp silicone to aid sealing.
- Mon Aug 03, 2015 6:11 pm
- Forum: Lambretta Tech
- Topic: Missing mag side retainer : rebuild??
- Replies: 8
- Views: 2470
Re: Missing mag side retainer : rebuild??
No, its there for a purpose. I'm afraid a strip down again of the mag housing is required, unless you've changed from an LI/SX type crank to a GP style crank, as it's not needed on the GP style crank.
- Tue Jul 21, 2015 1:22 pm
- Forum: Lambretta Tech
- Topic: Jumping out of third gear..................
- Replies: 1
- Views: 1090
Jumping out of third gear..................
when under load? Any pointers? Tried adjusting cables.
- Sat Jul 18, 2015 5:22 pm
- Forum: Lambretta Tech
- Topic: Scoot RS Ignition switch
- Replies: 2
- Views: 1275
Re: Scoot RS Ignition switch
Sorted
- Sat Jul 18, 2015 12:40 pm
- Forum: Lambretta Tech
- Topic: Scoot RS Ignition switch
- Replies: 2
- Views: 1275
Scoot RS Ignition switch
Whilst in Brittanny recently, my ScootRS ignition switch key wouldn't switch off due to key locked in barrel (tumblers must have got fecked), so had to stall her to stop engine. Got home and ordered new one from well liked dealer on here. Swapped over, but the green wire from the new switch is earth...
- Thu Jun 25, 2015 11:30 am
- Forum: Lambretta Tech
- Topic: Help...killing plugs
- Replies: 14
- Views: 5640
Re: Help...killing plugs
Get a Nippon Denso W24EU. Never had a problem since I changed to them. Had dodgy NGK's in the past.
- Mon Jun 15, 2015 12:34 pm
- Forum: Lambretta Tech
- Topic: Fork spring compressor tool
- Replies: 7
- Views: 2407
Re: Fork spring compressor tool
'Twas I Steve. Didn't save the photos thoughshocky wrote:To help stop scratches someone posted a pic of plastic milk contaners cut and wrapped around the fork boot
- Thu Jun 11, 2015 10:23 am
- Forum: Lambretta Tech
- Topic: Lammy starts but dis and backfires!
- Replies: 33
- Views: 9587
Re: Lammy starts but dis and backfires!
If it's kicking out a lot of spitback through the carb at idle, then it's probably a reed come loose.
- Tue Jun 09, 2015 1:53 pm
- Forum: Lambretta Tech
- Topic: Timing Strobe
- Replies: 7
- Views: 3738
Re: Timing Strobe
I think that means if you run the strobe off the scooter's battery rather than a separate battery not connected in any way to the scooter. And if you use the strobe with the sliding clip that goes over the HT lead, make sure the arrow on the clip is pointing towards the spark plug.