Search found 1254 matches
- Wed Aug 03, 2016 6:23 pm
- Forum: Lambretta Tech
- Topic: Egt vs cht
- Replies: 3
- Views: 2010
Re: Egt vs cht
Koso do an AC to DC converter for less than £20 which I hid under the hornstem to power a Stage 6 egt. An EGT will register far quicker than CHT gauge.
- Sun Jul 31, 2016 5:23 pm
- Forum: Lambretta Tech
- Topic: carb adjustment
- Replies: 3
- Views: 1787
Re: carb adjustment
Try the 264 with needle on bottom clip and hopefully it will splutter, then move the clip up a notch at a time until it runs clean. All the 25 mm carbs I've fitted have needed idle jets in the 40's range.
- Sat Jul 30, 2016 6:19 pm
- Forum: General Scooter Chat
- Topic: Kick start on GP
- Replies: 3
- Views: 1686
Re: Kick start on GP
You were probably wearing platform shoes in those days or it may have had an SX lever fitted?
- Fri Jul 29, 2016 6:44 pm
- Forum: Lambretta Tech
- Topic: Leaking franspeed tourer
- Replies: 12
- Views: 5459
Re: Leaking franspeed tourer
Realistically if your end can is leaking oil then you are either running too rich, too much oil or not riding hard enough
- Sun Jul 24, 2016 7:49 pm
- Forum: Lambretta Tech
- Topic: Drive side sliding dog.
- Replies: 6
- Views: 2942
Re: Drive side sliding dog.
It sounds to me that the top cap wasn't fitted correctly or the drive bolt was loose for the rubbing to show on the side case. It won't cost the earth to replace all the parts from Restorations or AF then you know all is good.
- Fri Jul 22, 2016 9:46 pm
- Forum: Lambretta Tech
- Topic: small end bearing
- Replies: 2
- Views: 1824
Re: small end bearing
I use Koyo ones at 22.5 wide,so 16x20x22.5 but measure the piston first and allow 0.5 clearance.
- Fri Jul 22, 2016 9:39 pm
- Forum: Lambretta Tech
- Topic: Disappointing RB20.
- Replies: 77
- Views: 21080
- Fri Jul 22, 2016 5:32 pm
- Forum: Lambretta Tech
- Topic: Lambretta J50 Deluxe with Jollymoto pipe
- Replies: 12
- Views: 6832
Re: Lambretta J50 Deluxe with Jollymoto pipe
Could you fit spacers under the mag bracket to move the pipe out? How is the pipe fastened to the bracket?
- Wed Jul 20, 2016 5:37 pm
- Forum: Lambretta Tech
- Topic: Not pulling...
- Replies: 15
- Views: 7078
Re: Not pulling...
It's an easy mistake to make.As for the running issue the weather may have richened things up too much?
- Wed Jul 20, 2016 5:00 pm
- Forum: Lambretta Tech
- Topic: Not pulling...
- Replies: 15
- Views: 7078
Re: Not pulling...
Gear cables right way round?