i might fit this engine
lol
Search found 1547 matches
- Wed Jan 28, 2009 10:51 pm
- Forum: Show us yer Scoots!!
- Topic: new project
- Replies: 34
- Views: 9072
- Tue Jan 27, 2009 10:19 pm
- Forum: Lambretta Tech
- Topic: Fork Buffer Position
- Replies: 8
- Views: 9113
Re: Fork Buffer Position
i do the same as i said on the lcgb
- Tue Jan 27, 2009 8:32 am
- Forum: Lambretta Tech
- Topic: Rear Shocks
- Replies: 10
- Views: 4276
Re: Rear Shocks
hagon for a tourer and escort for anything else imho
- Tue Jan 27, 2009 8:31 am
- Forum: Lambretta Tech
- Topic: Lambo crank reedvalve
- Replies: 16
- Views: 6001
Re: Lambo crank reedvalve
looks like a starting motor
- Mon Jan 26, 2009 8:47 pm
- Forum: Show us yer Scoots!!
- Topic: kettering scooters Dac 250!!
- Replies: 5
- Views: 4242
Re: kettering scooters Dac 250!!
cheers will pass this on to chris ,without chris(cs engineering) none of this would be possible.
- Mon Jan 26, 2009 8:03 pm
- Forum: Show us yer Scoots!!
- Topic: The Imposter
- Replies: 3
- Views: 2242
Re: The Imposter
well done m8 ,very nice bike
- Mon Jan 26, 2009 8:17 am
- Forum: Lambretta Tech
- Topic: Seat recomendations
- Replies: 2
- Views: 1527
Re: Seat recomendations
def the electronic copies mate,ask dave
- Sun Jan 25, 2009 11:16 pm
- Forum: Show us yer Scoots!!
- Topic: kettering scooters Dac 250!!
- Replies: 5
- Views: 4242
Re: kettering scooters Dac 250!!
it will be similar to this http://www.flickr.com/photos/anne-mark- ... 036665733/
- Sun Jan 25, 2009 3:10 pm
- Forum: Lambretta Tech
- Topic: Tillotson carbs ?
- Replies: 11
- Views: 4410
Re: Tillotson carbs ?
built in fuel pump cos no float bowl, two adjusting screws one for low to mid mix and one for mid to hi mix, as for parts never needed any ,tillotsons are small but get exxpensive when you go over 20mm, mikunis are a much better carb and are fairly small as well
- Sun Jan 25, 2009 10:49 am
- Forum: Lambretta Tech
- Topic: Tillotson carbs ?
- Replies: 11
- Views: 4410
Re: Tillotson carbs ?
yes i used one on my chop (pride)and we now use the mikuni version on the dac engine . brill carb eith a butterfly valve not a slide so instant throttle response can be mounted at any angle as well . mikuni do loads of different sizes as well . if i ever put one on a ts1 i would use 28mm because of ...